Watch the video below to see how to use correctly ELM327 interface on VW cars, in 6 steps.

STEP 1: Plugged the ELM327 interface into jack

Usually, the jack is near to pedals

STEP2: put the key in the second position

Use a smartphone with Android operating system

STEP 3: turn on the GPS/Location

STEP 4: turn on Bluetooth and find OBDII

STEP 5: pair with OBDII using 1234 or 0000 passwords

STEP 6: acces Torque App from your smartphone (you need to have it already installed on your phone)

When you receive the “Connected to ECU OK” message or the blue icons stop flashing, that means the phone is connected.

What can you do with ELM327 interface :

1. Read/clean car faults
2. Turn off the Check Engine light
3. You can view engine sensor parameters in real-time

After you are done, remember to turn the contact off and take the ELM327 interface out from the jack.

HERE you can find All-Included Pre-Built Bundles HELIOS is 100% plug and play on almost every car:

Get the best car wax sprays, ceramic coatings and DIY car detailing products – manufactured in the USA at a fraction of the price:

Everyone at Wurzel Performance prides themselves in the quality of the products and services they provide:

Here you can find LED Indicator Lights and Brake Turn Signal Lights for you car:

If you enjoyed this video tutorial, make sure to give it a thumbs up and share it with your friends.
Also, don’t forget to LIKE and SUBSCRIBE!

If you have any suggestions about new tutorials, let us know in the comments section!