How to change MFA cluster display language for VW Audi Skoda Seat using VCDS / VAG COM (from German to English)

In this video we will show you how to change cluster display language for the VW Golf Mk4, Mk5, Bora, Jetta, Passat, Polo, Touran, Sharan, Skoda Octavia 1, Octavia 2, Fabia, Seat Leon, Cordoba, Ibiza, etc. using VCDS VAG COM. But to do that, you will need a VAG GOM (VCDS) tester and a laptop with VCDS software already installed. Then…

 

1.       Start the engine and connect the VCDS cable at the OBD2 port

2.       Plug the VAGCOM  (VCDS) cable into any USB port on your laptop

3.       Open the VCDS software that you have already installed on your laptop

Follow this steps: Select Controle Module / 17-Instruments / Adaption-10 / Documented adaption channels can be selected here / Laanguage / New Value / Test / Save / Yes / Done, Go back / Exit

Choose the language number that you need (in our case is 2 = English) writing the number in the New Value case or using the “Up” and “Down” (Dn) buttons

4.       Turn off the engine and disconnect the VCDS cable.

 

See also these VIDEO TUTORIALS for VW Golf Mk4:

How to remove VW flip key blade in 4 steps!

How to replace / change Audi, Seat, Skoda, VW key fob in 11 steps!

How to find PAINT CODE on a VW Golf Mk4 in just 10 seconds!

How to repair door lock cylinder on Audi, VW, Skoda, Seat in 3 steps!

Leave a Reply

Your email address will not be published. Required fields are marked *