TUTORIAL: How to replace Mazda CX-5 engine oil filter & oil change in 12 simple steps

10/11/202124/01/2022

In this video tutorial I will show you how to replace engine oil filter and change the oil in a 2012-2017 Mazda CX-5 2.2 Liter with 175 HP.

HERE you can find Mazda CX-5 Engine Oil Filter: – https://amzn.to/3wC1yW0

Required tools:
– ratchet and extension ratchet: https://amzn.to/2XTBW9F
– 8 mm socket (or Phillips screwdriver): https://amzn.to/3wu0x1U
– oil filter wrench socket removal tool: https://amzn.to/3EXU2Yj
– 8 mm hex key (wrench): https://amzn.to/3wuoOVM
– funnel (only if it’s necessary): https://amzn.to/2Fiorad
– special container for the used oil: https://amzn.to/3kiWMaO
– oil filter: https://amzn.to/3wC1yW0

1. Lift the car to have access at the underbody shield
2. Remove the small plastic cover from the oil filter using a Phillips screwdriver or an 8 mm socket
3. Remove the oil filter using an oil filter wrench socket
Use a special container to drain the oil from the oil filter
You can find Oil Filter Wrench Socket Removal Tool in the video description below!
4. Remove the engine cover
5. Remove the cap from the oil filler hole to drain the oil faster
6. Remove the plastic cover to have access at the drain plug
7. Remove the drain plug using an 8 mm hex key
Wait for the oil to drain. Collect the used oil in a special container.
8. Re-tighten the drain plug
9. Install the new oil filter using the oil filter wrench socket removal tool
10. Fill the engine with properly oil (we have used 5 Liter of Mazda Ultra DPF Original Oil 5W-30)
11. Fit the cap from the oil filler hole
12. Install the plastic covers back on the underbody shield.
Wait for 5 to 10 minutes for the oil to settle into the engine oil pan and then check the oil level using the dispstick.
Start the engine and let it to run for about 10 minutes and check for the leaks at the oil filter and drain plug.
Check again after 10 minutes with the engine off. If the oil level is below the min mark, we would recommend adding more oil.