Learn how to fix your car… in just a few steps!
In this video tutorial you will see what tail light bulbs do you have to use for Mercedes-Benz A-Class W168.
Brake light = P21W 12V
Reverse light = P21W 12V
Turn signal light = P21W 12V
Tail & fog light = P21W/4W 12V.
See also these VIDEO TUTORIALS for Mercedes-Benz:
How to reset service light / oil service on Mercedes-Benz A-Class in 6 steps!
How to check oil level on Mercedes-Benz C320 Kompressor!
Mercedes-Benz A-Class W168 battery and main fuse box location!
This video tutorial will show you where is the Mercedes-Benz A-Class W168 battery and fuse box location in 5 simple steps. The reason that we made this clip is because the battery and also the fuse box is not it the most convetional places, and is not easily spotted.
1. Slide the passenger seat fully backward
2. Remove the floor mat and look for the black turn tab laying flat (missing from out car) on the floor pan, flick up one side of the tab and undo anti-clockwise
3. Lift the floor panel out sliding from beneath the edge of centre bulkhead
4. Remove the plastic cover foam cushion.
If you intend replacing the battery, first you have to remove the negative terminal followed by the positive terminal. But before that, make sure that you have the radio code to re-start it.
See also these VIDEO TUTORIALS for Mercedes-Benz:
How to reset service light / oil service on Mercedes-Benz A-Class in 6 steps!
How to check oil level on Mercedes-Benz C320 Kompressor!
This VIDEO TUTORIAL will show you how to reset service light or service indicator on Mercedes-Benz W168 (1997 – 2004) in just 6 simple steps:
STEP 1: turn the key in the second position (don’t start the engine)
STEP 2: press immediately and very fast on the “000.0” button twice
STEP 3: turn the key off
STEP 4: turn the key in the second position
STEP 5: press and hold the “000.0” button for few seconds until the service interval is reset
STEP 6: release the button and turn the key off.
The next service interval it will be reset after 15.000 km.
If you want to check if the service light / oil service was correctely reset, turn the key in the second position and see if the keys still appears on display.
To change or replace the rear brake pads on a Mercedes-Benz C230 Kompressor you have to follow just 6 simple steps. Watch the video below:
To have acces to brake pads, first you have to remove the wheel. Then…
STEP 1: take the pin out from the caliper
STEP 2: remove the component that holds the brake pads in place
STEP 3: pull the caliper pistons with the screwdriver to take the brake pads out
STEP 4: replace the worn brake pads with the new ones
This is just a simulation, that’s why we used the same brake pads.
STEP 5: fix the the component that holds the brake pads in place
STEP 6: put the pin back inside the caliper
This is how you reset service light on a Mercedes-Benz A-Class (2004 – 2012):
STEP 1: turn the key in the second position
STEP 2: press quickly 3 times on the left buton on the cluster (you should see the “UB” on display)
STEP 3: go to “SERVICE DATA” pressing one of the arrow buttons on the steering wheel
STEP 4: go to “Confirmation” using “+” or “-“ buttons on the right side of the steering wheel
STEP 5: press the left button (menu button) on the steering wheel to select “Confirmation”
STEP 6: select “Full service” from the display menu pressing the left button (menu button) on the steering wheel
Wait until “Service confirmed” message appears on display.
Follow those 6 steps from the video below to learn how to reset service light on a Mercedes-Benz CLS:
STEP 1: turn the key to position one
STEP 2: push the reset button from the left side of the instrument cluster three times
STEP 3: scroll to the “Service menu” pushing the button with arrow up
STEP 4: push the “+” or the “-“ button until you see “Confirmation” on display
STEP 5: push on the right side of the button marked with two rectangles
STEP 6: push again on the same button (the one with two rectangles, on the right) to confirmed “Full service”
Then, you’ll have to see the message “Service confirmed”
Because this was just a simulation, the message that appears in the video is “Service not confirmed”
To verify if you did the reset correctly, you have to turn the key to position one and scroll through the display meniu to search if the “Service in xxx km” message is there
To see how to change an air filter on a Mercedes-Benz C230 Kompressor, you have to follow carefully the steps from the movie below:
After I showed you how to change the front brake pads, it’s time to change also those on the back of the car. Here, the operation is easier. Carefully watch the video and learn how to do it on the Mercedes-Benz C230 Kompressor:
This tutorial we’ll present you how to change rear brake pads on a Mercedes-Benz C230 Kompressor.
We’ll show you how to check the oil level on a Mercedes-Benz C-Class Coupe (2 door version), year 2004-2008, with the 1.8-liter petrol engine (C230 Kompressor) and 192 hp. Because you don’t have a dipstick, you have to do this verification from inside, from the multifunction display in the instrument panel. Watch the video below and learn how to do this in just a few steps.
